• High quality quartz sleeve
• Safe for inhabitant
• Kills Algae, Parasites, Harmful bacteria
• Combination with Carbon and Foam Filter
• Quiet and Reliable
• Ideal for saltwater, freshwater and pond.

Maintenance

• When the quartz sleeve gets dirty with any sludge build up, it must be kept clean to maximize the efficiency of UV light.
• In case of controlling parasites, prolong the exposure time of water to the UV light.  It can be accomplished by lowering flow of water. 
• UV sterilizer would be connected to a suitable filter device to trap any suspended particles that can be attached on the quartz sleeve.
• Replace an UV bulb when lamp effectiveness declines with time.  It is recommended to replace UV bulb every Six Months.
• This UV sterilizer can be used for saltwater, freshwater aquariums and pond.
• Maximum aquarium size is calculated by UV dosage that kills free-floating algae and bacteria at 30,000 pw/cm2 and tank turn over of 3 to 4 times per hour.

Structure of UVF-9

When cleaning the bio-sponge and the active carbon box in the filter cylinder, you just need to open the bottom plate and pull them out

When you need to clean the quartz tube or replace the lighting tube, just pull out the filter cylinder and switch the rotation switch

Safety Instruction

• Make sure that electrical voltage is compatible with voltage printed on the filter label.
• Always use a properly grounded electrical outlet.
• To avoid electrical shock and /or electrical short, use a drip loop to prevent water travel along the power cord
• Ensure pump is securely installed before operation.
• Pump should only be used with water.
• Do not operated a dry filter to avoid permanent damage.  The filter should always be used with water.
• Do not operate filter if it is damaged, malfunction and/or if there is a problem with the power cord.
• Always unplug the filter from the electrical outlet when not in use, before replacing of cleaning pars.  Do not yank power cord to unplug it from the electrical outlet.
• Do not install or store pump where it can be extreme weather conditions or temperature below freezing.
• If an extension cord is necessary, use a cord with the proper rating.  A cord rated for less amperes or watts than the pump rating may result in overheating.
• Do not attempt to repair filter at home.  If service is needed, return filter to an authorized service center for service.
• UV Clarifier brings ultraviolet radiation when it is working which is harmful to the human eyes and skin, avoid eye contact and skin contact with the UV light at all times.  Remember to switch off the power before opening up the unit.
• When an "Acute Collision" or "A drop of the Unit" happens, please check to see if there is any crack on the quartz tube and UV lamp.  If any crack or breakages happens, you must replace the broken parts before using the unit again.